Supply & Manufacturing
Gutter Guard Primers, Sealants and Tools in Australia
Manufactured in Australia, supplied nationwide
- Preparation products matched to our adhesive
- Rollers & applicators for correct bonding pressure
- Saddles & angle trims for a clean finish


Get in touch with our team

CSIRO flammability high index rating

VHB adhesive fixing
Proudly manufactured in Australia with internationally sourced materials
Lake Macquarie / Hunter Valley

Year Gutter Guard warranty
Up to 20 stainless with 3M VHB, up to 15 aluminium. Certified installer required. T&Cs apply

Over 30 Years of Industry Experience

+25 years of HIA membership


What Makes a Fix Hold
An adhesive fix is only as good as the surface underneath it. At Leaf Free Gutter Guard, we supply the Prepclean, Primetite and tools that prepare a roof properly, because that preparation is what decides whether our Gutter Guard is still holding in fifteen years or lifting in three.
Roofs collect grime, oxidised coating and residue that adhesive can't grip. Cleaning that off, priming where needed and applying even pressure along the tape is the whole job. Everything below is stocked alongside the Gutter Guard and ships anywhere in Australia.
Call 1300 456 678 if you're unsure what a particular roof needs.


The Full Range
Each product handles a different step of the fix.

Leaf Free Prepclean isopropyl cleaner, in spray & 1L tin

Primetite primer for surfaces needing extra adhesion

Pressure rollers & applicators for even bonding

Saddles & angle trims for edges, valleys & finishing

Preparation Products
Preparation Products
- Prepclean
- Primetite
Prepclean is an isopropyl-based cleaner used to strip dust, oils and residue off the roof surface before the Gutter Guard goes down. It's available as a spray for smaller areas and in a 1L tin for full runs.
Primetite is the primer used where a surface needs more than cleaning to take adhesive reliably. On older or heavily weathered roofs it's the difference between a bond that grips and one that never quite does.

Fitting Tools and Trims
Fitting Tools and Trims
- Pressure Roller
- Saddles
- Angle Trim
Leaf Free Patented Adhesive System
A roller is used to apply pressure to the 3M VHB tape to ensure proper adhesion.
Traditional Trims, Saddles and Screws Method
Angle trims hold the Gutter Guard at the gutter edge, while saddles secure the gutter guard to the roof sheets and valleys.
Everything you need. One resource hub.
Technical documents, product information, installation resources and videos — all in one place.
Frequently Asked Questions
Adhesive bonds to the surface it touches, so dust, oxidised coating and oily residue all sit between the tape and the roof. CLEANING IS MANDATORY USING PREPCLEAN
Older, chalky or heavily weathered surfaces often need priming even after cleaning, because the top layer of coating is no longer sound. Newer roofs in good condition usually take adhesive well with cleaning alone. PRIMETITE IS MANDATORY FOR WHEN USING STAINLESS BECAUSE THE STAINLESS GUTTER GUARD IS FAR MORE RIGID THAN ALUMINIUM.
Yes. Adhesive tape reaches full strength only when it's pressed firmly and evenly onto the surface, which is what a pressure roller is for. Skipping this step is one of the most common causes of mesh lifting later.
Get the preparation right the first time. Call 1300 456 678 for advice or to order.



