Fitting & Installation
Gutter Cleaning and Repair in Australia
Manufactured in Australia, supplied nationwide
- What preparation a roof needs before Gutter Guard
- Prepclean & Primetite for surface preparation
- Gutter Guard that cuts how often cleaning is needed


Get in touch with our team

CSIRO flammability high index rating

VHB adhesive fixing
Proudly manufactured in Australia with internationally sourced materials
Lake Macquarie / Hunter Valley

Year Gutter Guard warranty
Up to 20 stainless with 3M VHB, up to 15 aluminium. Certified installer required. T&Cs apply

Over 30 Years of Industry Experience

+25 years of HIA membership


Preparing Gutters for Gutter Guard
Gutter cleaning is the step everyone wants to skip and the one that decides whether an adhesive fix lasts. At Leaf Free Gutter Guard, we manufacture Leaf Free Gutter Guard rather than offer a cleaning service, but we supply the preparation products used across Australia to get a roof ready, and it's worth knowing what good preparation involves.
Gutters need to be emptied, washed and fully dried. The surface where tape will sit has to be free of grit, oxidised coating and oily residue, which is what our Prepclean and Primetite range is for.
Call 1300 456 678 to talk it through.


What to Check First
Older guttering often needs attention before anything is fitted over it.

Rust, splits & failed joints along the gutter run

Sagging brackets & falls that hold water

Blocked or partially blocked downpipes

Fascia damage from long-term overflow
Cleaning Less Often Afterwards
Once Gutter Guard is on, the pattern changes. Leaves dry on the surface and blow clear rather than packing down into standing water, and the sludge layer that builds in an unprotected gutter largely stops forming.
Fine grit still finds its way through over the years, so an occasional check remains sensible. What disappears is the annual clear-out and the damage that comes from leaving it too long. See our residential range for Gutter Guard options.
Gutter and Downpipe Maintenance
From the installation brochure
Preparing the Gutter Before Gutter Guard Is Fitted
Step 1: Clear the gutter
Remove all debris from gutter and downpipes.
Step 2: Clean the contact surface
Thoroughly clean roof sheeting and the bead of gutter where bonding will take place, using Step 1 Cleaner.
Step 3: Make sure it is dry
Never install in damp conditions. In lower temperatures, ensure condensation is removed from the surface.
Step 4: Check the condition
Contact surfaces must be clean, dry and in good condition before the Gutter Guard goes on.
Preparation, Fitting & Installation Guide
Our brochure sets out surface preparation and fitting steps for tile and metal roofing.
Warranty terms: the current Warranty document (PDF, opens in a new tab) controls where older brochures or marketing documents differ.
Get the guidance you need for proper preparation, fitting and installation of your Leaf Free Gutter Guard system.
View Installation GuideFrequently Asked Questions
It depends almost entirely on tree cover, though twice a year is a common rule of thumb and homes under gums often need more. Properties near eucalypts drop bark and gumnuts year-round rather than in one autumn burst.
Adhesive tape won't bond to a damp surface, and moisture trapped under the tape prevents it reaching full strength. Fitting is best done on a dry day once the gutters have had time to dry out completely.
Water backing up over the gutter edge runs down fascia boards and walls, which leads to rot, staining and damp inside over time. Wet leaf litter also holds moisture against the metal, which accelerates rust.
Getting a roof ready for mesh? Call 1300 456 678 for preparation advice.
Call 1300 456 678


